1. How do I turn on the night vision (infrared) feature? 1. How do I turn on the night vision (infrared) feature? FIRMWARE VERSION: Before 11-15-2004 Under "Configuration > GPIO", check both "Enable and "Automatically". If you wish to turn off night vision, uncheck "Enable". FIRMWARE VERSION: 11-15-2004 or after Under "Configuration > GPIO > IR Lamp", check "Automatic" or "Trigger". If you wish to turn off night vision, do not check either of the boxes.
2. How do I update the firmware on my camera?
Then hit "Upload".
Wait for the camera to update the firmware. It will reset itself
in 60 seconds.
3. How do I check the version of my firmware?
4. How do I reset the camera?
5. What is the camera's default IP?
6. Can this camera be used for outdoors?
7. How do I enable ActiveX so I can view the camera? For Internet Explorer, go to "Tools > Internet Options > Security".
Click on the "Custom Level" button near the bottom of the window.
Under ActiveX Controls and Plug-ins, change all Disabled to Prompt. Re-enter the camera link into your browser again to view the camera.
8. Motion detection feature freezes my camera. What should I do? Please set a higher interval when sending email or FTP. 9. What do I have to configure in the router so people can view this camera from the internet? For D-Link routers, please click here. For Linksys routers, please click here.
|
